Carbon Primary Drive Belt for Light E-Moto Platforms
This EBG carbon primary drive belt is the shared replacement and upgrade belt used across compatible Surron Light Bee, Talaria XXX, E Ride Pro, Segway X260, Ventus, 79Bike, ReRode and SRPNT primary-drive systems. Instead of duplicating the same physical belt across multiple product pages, this page brings the compatible applications and belt-width options into one clear listing.
Compatible models
| Brand | Compatible models |
|---|---|
| Surron / Segway | Surron Light Bee X and Segway X260 |
| Talaria | Talaria XXX |
| E Ride Pro | Pro S, Pro SS and Pro SR applications using the listed belt setup |
| Ventus | Ventus One Plus and Ventus V1+ EVO |
| 79Bike | Falcon M, Falcon Pro and Falcon GT |
| ReRode | ReRode R1 and R1+ |
| SRPNT | SRPNT X3 |
Select the correct belt
Choose the belt option that matches the pulley system installed on the bike. Confirm the printed belt size, width, tooth profile and pulley alignment before ordering. An 18mm belt and a 20mm belt are not interchangeable unless the installed pulley system is designed for that width.
Why use an EBG carbon primary drive belt?
- Carbon-reinforced construction: Designed for consistent power transfer under repeated acceleration.
- Quiet operation: A correctly aligned and tensioned belt reduces drivetrain noise.
- Low maintenance: No lubrication and no metal-chain rust.
- Trail-ready: Suitable for riding conditions involving dust, mud, water and elevated drivetrain temperatures.
- One clear fitment page: Customers can confirm the bike model and pulley configuration without navigating duplicate products.
Specifications
| Product type | Carbon-reinforced primary drive belt |
|---|---|
| Brand | EBG |
| Available width | Select 18mm or 20mm according to the installed pulley setup |
| Rated drivetrain support | 560-8M-20mm — up to 40 kW at the shaft; 560-8M-18mm — up to 36 kW at the shaft (actual output) |
| Maintenance | No lubrication; inspect tension, tracking and wear regularly |
| Package | 1 EBG carbon primary drive belt in the selected size + 1 complimentary EBG belt tension adjustment tool |
Recommended operating range: For reliability and belt service life, use the 560-8M-20 belt on systems producing approximately 25–30 kW maximum output at the shaft. More importantly, output torque should not exceed 65–70 Nm.
Carbon belt maintenance
For street riding, clean the belt and use a carbon-belt-safe maintenance solution every 1,000 km. After every enduro or off-road ride, remove mud, sand and grit, then apply the maintenance product according to its instructions. Regular care helps protect the belt surface and extend carbon-belt service life.
Installation guidance
Inspect the front pulley, rear pulley and jackshaft before installation. Replace damaged or unevenly worn pulleys, align the drive correctly and set belt tension to the specification of the installed pulley system. Recheck alignment and tension after the first ride. Professional installation is recommended for modified or high-output drivetrains.
| Belt Size | 560-8M-18mm (For Pulley Stock & EBG Pulley), 560-8M-20mm (For EBG Pulley) |
|---|
Reviews
There are no reviews yet.